Iwachu Kettle Tetsubin Arare Kiyomo
Tetsubin Flat Arare Kiyomo Cast Iron Kettle
- The Cast Iron Collection.
- 8-1/2" x 7-1/2" x 9-1/2"h. - 1.4L / 47 oz. capacity.
- Cast Iron.
- Can be used directly on gas flame to boil water.
- IH compatible.
- Dry thoroughly to store.
- Please check the product for any cracks or other damage on the main unit and that the handle is solid.
- Made in Japan by Iwachu Japan.
- After lightly rinsing the body, fill about 80% of the capacity with water and bring to a boil over medium heat. Then discard the water. Repeat this 2 - 3 times. Then discarded boiled water should be colorless.
- Bring to a boil over medium heat again. If you boil the water with low heat, the water will become cloudy.
- Do not leave the remaining hot water inside the kettle, but transfer to another pot or vessel. Be sure to empty of water. Leaving hot water in the kettle for a long time may cause rust or cloudy water.
- Allow teapot to cool completely after each use before cleaning.
- Do no use soaps or detergents.
- Avoid contact with salt/oils.
- Do not leave water or tea in pot for extended period of time.
- Remove the lid and dry the inside completely with residual heat or a short light flame before storing. Do not touch the interior of the hot kettle!
- Red spots appear on the interior with continued use adn then a white film of hot water scale appears - please do not rub this off. If a film of scale is formed, the water will remain transparent even if the interior is red and your tea water will taste even better. Please be assured that iron rust does not harm your body.
- Wipe the exterior completely dry with a clean cloth.
- You can create a unique luster by gently wiping it with a tightly wrung out cloth while the iron kettle is still hot (such as after boiling water).
- If the boiled water becomes cloudy due to rust or if the boiled water has an odor, boil sencha. (after lightly rinsing the kettle, add water up to the 8th minute. Add about a teaspoon of sencha in a dashi or tea pack, and boil for about 30 minutes on medium heat or lower. At this point, you may want to remove the lid to prevent overflow of the water. Discard the water which may be discolored. Rinse lightly and boil water again one or twice before using. Continue to use once red rust/metal color disappears. The color will soften as the water boils).